Re: Issue with centroiding

Posted by karenacollins on Feb 24, 2022; 8:50am
URL: http://astroimagej.170.s1.nabble.com/Issue-with-centroiding-tp1786p1787.html

Hi Gary,

When you have faint stars near bright stars, the centroiding operation is likely going to move the aperture to the brighter star as you have found. The only way to work around it is to turn off centroiding for the faint star (or all of the stars except the first one in the radec list as described below).

You can specify to centroid or not centroid each aperture in the .radec input file format using a 1 or 0, respectively, in the 4th column as shown below.

# Aperture file format for use in AstroImageJ (.radec format)
# RA (should have proper motion applied)
# Dec (should have proper motion applied)
# Ref Star: 0=target star, 1=ref star
# Centroid: 0=do not centroid, 1=centroid
# Magnitude (optional)
# RA,            Dec,      Ref Star, Centroid, Mag
12:14:48.899,  -63:05:12.346, 0, 1, 10.167

If all apertures are offset somewhat from stars, then the plate solution for the image may not be precise. Or, if only some apertures are not centered on the star, the problem may be that those stars have higher proper motion and the proper motion has not been accounted for in the RA and Dec coordinates.

A workaround for a plate solution that is somewhat off is to set the first aperture to centroid and the others to NOT centroid in the radec file. After loading the radec file into AIJ and starting Multi-Aperture, ENABLE "Use previous N apertures" and DISABLE "Use RA/Dec to locate apertures". Then click Place Apertures and click near the star corresponding to the first entry in the RA/Dec file. This will cause the first aperture to centroid on the star where you clicked, and the other apertures will be placed relative to their distance from the first star (T1) according to difference in RA/Dec coordinates, rather than the absolute RA and Dec.

If you have some apertures that are still not centered on a star, zoom in close on the aperture, left-click and hold the mouse button down inside the aperture and drag the aperture by hand to center it on its respective star. Release the mouse button when it is centered. Once they are all centered, press enter or right click to start photometry.

In case you want to analyze the field again in the future, be sure and save a new radec file from AIJ after you run photometry. Then you can reload the adjusted aperture locations later.

Karen